July 19, 2024


It's A Shop Adventure

How to create a 3D jewellery set

How to create a 3D jewellery set

What you will need:

Findings – These can be distinctive based on own choices:


Star Assortment right before polishing


  1. To start with you will need to saw/file the sprue off the elements
  2. You can pre buff/ pre polish the star items which would make cleaning a lot easier after soldering
  3. Using buff sticks to buff back again the solid complete heading from coarse to wonderful
  4. As soon as you have received to high-quality buff paper you can start to polish working with luxi compound –blue for initial phase with the calico mop
  5. There are manual marks on the point of the star pendant and earrings you want to solder leap rings to
  6. You can file soar rings with triangular file to give them an angle at the finishes so they sit flat versus the point of the star
  7. Implement solder paste exactly where the information marks are on the stars
  8. On the soldering block, force the soar ring in opposition to the stars manual marks and use tweezers to maintain the soar ring in put
  9. Making use of the hand torch, warmth up the sound star and at the time it is beginning to change color slowly and gradually go together to the soar ring so it gets to tempreture at similar time till the solder melts and joins the items jointly
  10. Quench and set it in pickle, rinse just after pickling to clean off acids.
  11. If you didn’t buff and pre polish formerly now you will have to have to buff again the forged finish and if you require to remove any extra solder
  12. Polish the piece making use of luxi compound – blue for initially phase making use of a calico mop
  13. Then polish with White luxi compound and a fluffy mop
  14. For your earrings you can open up your ear wire and then shut it back together
  15. For the star pendant necklace, dependent on the bail you choose you can both increase it immediately the the jump ring or if necessary you might want to include yet another smaller soar ring in advance of the bail.
  16. Ultrasonic or clear off any residual polish and insert a chain to the pendant.
Concluded Jewellery Set

Optional: you can possibly entirely close your results by soldering them throughout soldering move 9 or leave the findings semi open and just pushed collectively .

Conserve this for afterwards

Author: Amarah Mann